
English 3
2. BEFORE INSTALLATION
Do not exert pressure on the resin parts when opening the unit or when moving it after opening.
Be sure to check in advance that the refrigerant to be used for installation is R410A. (If a wrong
refrigerant is charged, the unit will not properly operate)
• For the installation of an outdoor unit, refer to the installation manual attached to the outdoor unit.
• Do not dispose of any parts necessary for installation until the installation is completed.
• Decide the route for carrying the unit to the installation site.
•
When hanging the unit for lifting, use a sling of soft material (made of cloth, nylon, etc.) as shown below.
(Refer to Fig. 1)
2-1 PRECAUTIONS
• When selecting installation site, refer to the paper pattern (part of packaging material).
• Do not use the unit in locations where the salt content in the air is high such as beachfront, or where the
voltage fluctuates such as factories, or where the base vibrates such as automobiles or marine vessels.
• Before opening the control box lid and performing the wiring operation, remove the static electricity charged
to your body. Otherwise, electrical parts may be damaged.
2-2 ACCESSORIES
Check the following accessories are included with the unit.
Name (1) Bracket for installation
(3) Hole protection
rubber
(4) Bush Insulation for fitting
Quantity 1 set *1) 2 pcs. 1 pc. 1 each
Shape
(2) Screw (M4 × 10), 1 pc.
(5) For gas pipe
(6) For liquid pipe
Name (7) Cover (8) Clamp (9) Installation pattern
(10) Dew proof
material
Quantity 1 pc. *2) 5 pcs. 1 pc. 1 pc.
Shape
(1) Horizontal hanging (2) Vertical hanging
Sling
*Be sure that the sling
does not slide.
Sling
Apply cloth or corrugated
cardboard so that the air
discharge grille and air inlet
grille will not be damaged.
Fig. 1
Do not dispose of any parts necessary for installation until the installation is completed.
Also used as a
packaging material
3P249378-4D_FM6.book Page 3 Thursday, December 15, 2011 10:00 AM
Comentarios a estos manuales