Daikin FVQ140CVEB Manual de instalación Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
English 9
The outdoor unit is charged with refrigerant.
The refrigerant piping can be taken out from the following side of
the unit.
Left side, Right side, Back side, Bottom side
You must decide from which side you intend to take out the
refrigerant piping.
Be sure to use both a spanner and a torque wrench together as
shown in the drawing, when connecting or disconnecting pipes
to/from the unit. (Refer to Fig. 9)
*Using a tool other than a spanner can damage the head of the
flare nut, and gas leakage can occur due to tightening failure.
Refer to “Table 2” for the dimensions for flaring.
When connecting the flare nut, apply ester oil or ether oil to the
inside of flared section, and turn the nut spin 3-4 times by hand
before screwing in. (Refer to Fig. 10)
CAUTION
Be careful not to damage the flare section.
Table 2
Refer to “Table 2” to determine the proper tightening torque.
CAUTION
Overtightening may damage the flare and cause a refrigerant leakage.
When you do not have a torque wrench, use Table 2 as a rule of thumb.
When you keep on tightening the flare nut with a spanner, there is a point where the tightening torque
suddenly increases.
From that point, further tighten and turn the flare nut the angle shown below. (Refer to Table 3)
After the work is finished, make sure to check that there is no leak.
Unless you tighten as instructed, (if it is loosely tightened), it may lead to the refrigerant leakage (slow
leak) and cause malfunction of the device (such as insufficient cooling or heating).
Table 3
Pipe size Tightening torque Flare dimensions A (mm) Flare
φ9.5 (3/8”) 32.7 - 39.9 N·m 12.8 - 13.2
φ15.9 (5/8”) 61.8 - 75.4 N·m 19.3 - 19.7
Pipe size Further tightening angle Recommended arm length of tool
φ9.5 (3/8”) 60 to 90 degrees Approx. 200mm
φ15.9 (5/8”) 30 to 60 degrees Approx. 300mm
Fig. 10
Apply ester or ether oil to this face.
Torque wrench
Spanner
Pipe union
Flare nut
Fig. 9
A
45˚
R0.4-0.8
90˚
3P249378-4D_FM6.book Page 9 Thursday, December 15, 2011 10:00 AM
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comentarios a estos manuales

Sin comentarios