Daikin FTXG35CVMBS Especificaciones Pagina 61
- Pagina / 194
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Instruction Si04-402
52 System Configuration
13
■
To start COMFORT AIRFLOW operation
5. Press “COMFORT AIRFLOW button”.
The flap orientation will change, preventing air from blowing directly on the
occupants of the room.
•“ ” is displayed on the LCD.
〈COOL/DRY〉 The flap will go up.
〈HEAT〉 The flap will go down.
■
To cancel COMFORT AIRFLOW operation
6. Press “COMFORT AIRFLOW button” again.
Note
• When “SWING button ” is selected, the flap swinging
range depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, which
tends to collected at the bottom of the room, and hot air,
which tends to collect near the ceiling, throughout the
room, preventing areas of cold and hot developing.
Comfort Airflow
• The air flow is set automatically.
• The air direction is as shown in the figure at right.
■
■■
■
ATTENT ION
• Always use a remote controller to adjust the flap angle.
If you attempt to move it forcibly with hand when it is
swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers
angles.
10˚
5˚
40˚
80˚
75˚
30˚
COOL/DRY
approx. 10˚~40˚
FAN
approx. 5˚~80˚
HEAT
approx. 30˚~75˚
In COOL or DRY mode
In HEAT or FAN mode
STOP
STOP
HEAT
80˚
COOL
5˚
In COMFORT AIRFLOW mode
STOP
- Inverter Pair 1
- Indoor Unit 2
- Outdoor Unit 2
- Table of Contents iii 4
- 1. Introduction 6
- 1.1.3 Inspection after Repair 8
- 1.1.4 Using Icons 9
- 1.1.5 Using Icons List 9
- Si04-402 10
- List of Functions 1 10
- 1. List of Functions 11
- Specifications 3 12
- 1. Specifications 13
- 230V, 50Hz 14
- 1.1 Indoor Unit 17
- PCB(2): Signal Receiver PCB 18
- 1.2 Outdoor Unit 19
- PCB(2): Filter PCB 20
- Function and Control 13 22
- 1. Main Functions 23
- Si04-402 Main Functions 26
- Function and Control 17 26
- (R4085) (R4085) 27
- 1.5 Programme Dry Function 28
- 1.6 Automatic Operation 29
- 1.7 NIGHT SET Mode 30
- 1.8 INTELLIGENT EYE 31
- TPF=(20min.) 32
- ON / OFF button 33
- 2. Function of Thermistor 34
- 3. Control Specification 35
- 3.2 Frequency Control 36
- 3.3.1 Preheating Operation 37
- 3.3.4 3-minutes Standby 38
- 3.4 Discharge Pipe Control 39
- 3.5 Input Current Control 39
- 3.7 Heating Peak-cut Control 40
- 3.8 Fan Control 41
- 3.10 Defrost Control 42
- 34 Function and Control 43
- Function and Control 35 44
- 36 Function and Control 45
- 3.12 Malfunctions 46
- 3.13 Forced Operation Mode 47
- 3.14 Additional Function 47
- System Configuration 39 48
- 1. System Configuration 49
- 2. Instruction 50
- Installation site 51
- Electrical work 51
- System relocation 51
- 2.2 Names of Parts 52
- Remote Controller 54
- To set the batteries 55
- ATTENTION 56
- To set the clock 57
- Si04-402 Instruction 58
- System Configuration 49 58
- Instruction Si04-402 59
- 50 System Configuration 59
- System Configuration 51 60
- 〈HEAT〉 The flap will go down 61
- 2.6 POWERFUL Operation 62
- 1. Press “SILENT button” 63
- 2.8 INTELLIGENT EYE Operation 64
- Notes on “INTELLIGENT EYE” 65
- 2.9 TIMER Operation 66
- 2.10 Care and Cleaning 68
- [ Maintenance ] 69
- [ Replacement] 69
- Before a long idle period 70
- 2.11 Troubleshooting 71
- Check again 72
- Case Check 72
- Disposal requirements 73
- C:3P119293-1 73
- Service Diagnosis 65 74
- 1. Caution for Diagnosis 75
- 3. Service Check Function 77
- Service Diagnosis 69 78
- 70 Service Diagnosis 79
- 4. Troubleshooting 80
- 72 Service Diagnosis 81
- Model Type Connector No 81
- Service Diagnosis 73 82
- Service Diagnosis 75 84
- Check No.01 85
- Service Diagnosis 77 86
- 78 Service Diagnosis 87
- Service Diagnosis 79 88
- Wired Remote Controller ) 89
- Service Diagnosis 81 90
- 82 Service Diagnosis 91
- Service Diagnosis 83 92
- 4.12 Compressor Lock 93
- 4.13 DC Fan Lock 94
- 86 Service Diagnosis 95
- Service Diagnosis 87 96
- 88 Service Diagnosis 97
- Service Diagnosis 89 98
- 90 Service Diagnosis 99
- Si04-402 Troubleshooting 100
- Service Diagnosis 91 100
- Troubleshooting Si04-402 101
- 92 Service Diagnosis 101
- Service Diagnosis 93 102
- 94 Service Diagnosis 103
- J3, J6, H9 104
- 96 Service Diagnosis 105
- Service Diagnosis 97 106
- 98 Service Diagnosis 107
- 4.23 Insufficient Gas 108
- Troubleshooting 109
- Check No.4 109
- Refer to P.102 109
- Check No.6 109
- Refer to P.104 109
- 4.24 Over-voltage Detection 110
- 5. Check 111
- Check No.5 112
- Check No.7 114
- Check No.8 115
- Check No.9 115
- 5.1.10 Power Transistor Check 117
- Removal Procedure 109 118
- 1. Indoor Unit 119
- Grille side 121
- Decorative 121
- (R3769)(R3768) 121
- Decorative plate 122
- Indoor Unit Si04-402 125
- 116 Removal Procedure 125
- Procedure Points 125
- Si04-402 Indoor Unit 128
- Removal Procedure 119 128
- 1.4 Removal of Lamp Cover 131
- (R3816) (R3813) (R3814) 132
- 124 Removal Procedure 133
- Removal Procedure 125 134
- 1.7 Removal of Outlet Grille 136
- 128 Removal Procedure 137
- Removal Procedure 131 140
- 1.9 Removal of Electrical Box 141
- Removal Procedure 137 146
- 1.10 Removal of PCB 147
- Loosen the screws of 148
- Release the front hook 148
- Layout of the wiring 149
- Loosen the screw and 149
- Removal Procedure 145 154
- 3. Remove the bearing 157
- Lift up the right part of 157
- Removal Procedure 149 158
- 2. Outdoor Unit 159
- Lead wire Propeller fan 162
- Outdoor Unit Si04-402 163
- 154 Removal Procedure 163
- When reassembling, make 165
- 2.2 Removal of Electrical Box 166
- Si04-402 Outdoor Unit 168
- Removal Procedure 159 168
- 160 Removal Procedure 169
- 2.4 Removal of Sound Blanket 170
- 162 Removal Procedure 171
- 2.5 Removal of Four Way Valve 172
- 164 Removal Procedure 173
- 2.6 Removal of Compressor 174
- Heat up the brazed part 175
- Lift the compressor up 175
- 2.7 Removal of PCB 176
- Loosen the 4 screws 177
- Undo the 3 hooks on 177
- Lift and pull out the 177
- Removal Procedure 169 178
- 170 Removal Procedure 179
- Others 171 180
- 1. Others 181
- (R2871) (R2872) 182
- Others Si04-402 183
- 174 Others 183
- Appendix 175 184
- 1. Piping Diagrams 185
- 2. Wiring Diagrams 186
- Wiring Diagrams Si04-402 187
- 178 Appendix 187
- IndexIndex 188
- Index iii 190
- Drawings & Flow Charts 192
Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Daikin FTXG35CVMBS
Acondicionadores de aire del sistema de división Daikin FUQ71BUV1B Manual de instrucciones
(15 paginas)
(15 paginas)
Acondicionadores de aire del sistema de división Daikin FXTQ54PAVJU Manual de instalación
(19 paginas)
(19 paginas)
Acondicionadores de aire del sistema de división Daikin RKS25E2V1B Manual de instalación
(14 paginas)
(14 paginas)
(30 paginas)
Acondicionadores de aire del sistema de división Daikin FHQ100BUV1B Manual de instrucciones
(15 paginas)
(15 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales