Daikin Remote Controller BRC1C61 Especificaciones Pagina 4

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 7
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 3
ED39-634 BRC1C62
Wired Remote Controller 53
3
Lower part of
remote controller
Upper Part of
Remote controller
PC Board
Indoor Unit
P1, P2
Indoor Unit
P1, P2
(Wired from the top)(Wired from the rear)
Notch the part for the wiring to
pass through with nippers, etc.
Ground the shielded
part on the indoor
unit side. (NOTE.2)
PC Board
NOTE) 1.Peel the shield and sheath for
the part that is to pass through
the inside of the remote control-
ler case, as shown in the figure
below.
2. Shield wire (2 wire) can be
used for remote controller
wiring, but it must confirm to
EMC (Electromagnetic Compat-
ibility) (European Directive).
3.Wire the indoor unit.
Connect the terminals on top of the upper part of
remote controller (P1, P2), and the terminals of the
indoor unit (P1, P2). (P1 and P2 do not have polarity.)
NOTE
When wiring, run the wiring
away the power supply wiring in
order to avoid receiving electric
noise (external noise).
4.
Reattach the upper part of remote controller.
Be careful not to pinch the wiring when attaching.
NOTE
1.The switch box and wiring for connection are not
included.
2.Do not directly touch the PC board with your hand.
If controlling one indoor unit with two remote
controllers
Change the MAIN/SUB changeover switch setting as
described below.
Set one remote controller tomain,and the other to sub.
NOTE
If controlling with one remote controller, be sure to set it
tomain.
Set the remote controller before turning power supply on.
is displayed for about one minute when the power supply is turned on,
and the remote controller cannot be operated in some cases.
Wiring Specifications
Sheathed vinyl code or cable
(2 wire) (NOTE.2)
0.75 1.25 mm
2
Wiring Type
Size
Peel the shield
and sheath.
S
M
S
M
Sub
Remote
Controller
Main Remote
Controller
(Factory Set)
PC Board
First, begin fitting from
the clips at the bottom.
Vista de pagina 3
1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios