Daikin FXHQ100MAVE Manual de instalación descargar pdf (Pagina 4)

2 English

• Do not install the air conditioner in the following locations:

1. Where there is a high concentration of mineral oil spray or

vapour (e.g. a kitchen).

Plastic parts will deteriorate, parts may fall off and water

leakage could result.

2. Where corrosive gas, such as sulphurous acid gas, is pro-

duced.

Corroding of copper pipes or soldered parts may result in

refrigerant leakage.

3. Near machinery emitting electromagnetic radiation.

Electromagnetic radiation may disturb the operation of the

control system and result in a malfunction of the unit.

4. Where flammable gas may leak, where there is carbon

fibre or ignitable dust suspensions in the air, or where vol-

atile flammables such as paint thinner or gasoline are

handled.

Operating the unit in such conditions may result in fire.

• The air conditioner is not intended for use in a potentially

explosive atmosphere.

2. BEFORE INSTALLATION

• When moving the unit while removing it from the carton

box, be sure to lift it without exerting any pressure on

other parts, especially, the refrigerant piping,drain pip-

ing, and other resin parts.

• Be sure to check the type of R410A refrigerant to be used

before installing the unit.(Using an incorrect refrigerant will

prevent normal operation of the unit.)

• The accessories needed for installation must be retained in

your custody until the installation work is completed. Do not

discard them!

• Decide upon a line of transport.

• Leave the unit inside its packaging while moving, until reach-

ing the installation site. Where unpacking is unavoidable, use

a sling of soft material or protective plates together with a

rope when lifting, to avoid damage or scratches to the unit.

• For the installation of an outdoor unit, refer to the installation

manual attached to the outdoor unit.

• Do not install or operate the unit in rooms mentioned below.

• Laden with mineral oil, or filled with oil vapor or spray

like in kitchens. (Plastic parts may deteriorate which

could eventually cause the unit to fall out of place, or

could lead to leaks.)

• Where corrosive gas like sulfurous gas exists. (Cop-

per tubing and brazed spots may corrode, which

could eventually lead to refrigerant leaks.)

• Where exposed to combustible gases and where vol-

atile flammable gas like thinner or gasoline is used.

(Gas in the vicinity of the unit could ignite.)

• Where machines can generate electromagnetic

waves. (Control system may malfunction.)

• Where the air contains high levels of salt such as that

near the ocean and where voltage fluctuates greatly

such as that in factories. Also in vehicles or vessels.

• This unit, both indoor and outdoor, is suitable for installation

in a commercial and light industrial environment.

If installed as a household appliance it could cause electro-

magnetic interference.

2-1 PRECAUTIONS

• Be sure to read this manual before installing the indoor unit.

• Entrust installation to the place of purchase or a qualified ser-

viceman. Improper installation could lead to leaks and, in

worse cases, electric shock of fire.

• Use only parts provided with the unit or parts satisfying

required specifications. Unspecified parts could cause the

unit to fall out of place, or could lead to leaks and, in worse

cases, electric shock or fire.

• Ventilate the room if refrigerant gas leakage occurs during

the installation work. Exposure gas to flame or hot object

may result in production of toxic gases.

• When the installation work is finished, check to make certain

that refrigerant gas is not leaking. Refrigerant gas leakage

and its exposure to flame or hot object in fan heater, stove,

cooking appliance, etc. may result in production of toxic

gases.

2-2 ACCESSORIES

Check the following accessories are included with your

unit.

2-3 OPTIONAL ACCESSORIES

• These are two types of remote controllers: wired and wire-

less. Select a remote controller according to customer

request and install in an appropriate place.

Tabl e 1

NOTE

• If you wish to use a remote controller that is not listed in

Table 1, select a suitable remote controller after consulting

catalogs and technical materials.

Name Drain hose

Insulation for

fitting

Quantity 1 set 1 each.

Shape

Hose × 1

Metal clamp × 1

(3) For gas pipe

(4) For liquid pipe

Name Sealing pad Clamp

Quantity 1 pc. 8 pcs.

Shape

Name Leveling

[Other]

• Operation manual

• Installation manual

Quantity 4 pcs.

Shape

Remote controller

Wired type

Wireless type

Heat pump type

Cooling only type

(1) (2)

(5)

(6)

(7)

01_EN_3P086154-2P.fm Page 2 Tuesday, March 31, 2009 5:26 PM

1 2 3 4 5 6 7 8 9 ... 12 13

Comentarios a estos manuales

Sin comentarios

Daikin FXHQ100MAVE Manual de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Daikin FXHQ100MAVE