Daikin FXAQ12MVJU Manual de instalación

MODELSWall-mounted typeFXAQ12MVJUFXAQ18MVJUFXAQ24MVJUSYSTEM Inverter Air ConditionersRead these instructions carefully before installation.Keep this m

8(5) Point the pipe in the direction it will be passed out.For bottom-right and back-right piping (Refer to Fig. 6)•Wrap the drain hose and the refrig

9(6) Hook the indoor unit onto the installation panel. (Refer to Fig. 9)• Placing buffering material between the wall and the indoor unit at this time

10 When screwing in the indoor unit• Remove the front grill. (Refer to Fig. 7)• Secure the indoor unit to the installation panel (1) with the securin

11• Refer to Table 1 for tightening torque.Table 1Not recommendable but in case of emergencyYou must use a torque wrench but if you are obliged to ins

12CAUTIONBe sure to insulate any field piping all the way to the piping connection inside the unit. Any exposed piping may cause condensate or burns i

13(2) Make sure the drain works properly.• After drain work is complete, perform a drain check by opening the front panel, removing the air filter, po

147-3 SPECIFICATIONS FOR FIELD SUPPLIED FUSES AND WIRE• Allowable length of transmission wiring and remote controller wiring are as follows.(1) Outdoo

15CAUTIONBe sure to attach the sealing material and putty (field supplied) to hole of wiring to prevent the infiltration of water as well as any insec

16[ PRECAUTIONS ]1. Use round crimp-style terminals for connecting wires to the power supply terminal block.(Refer to Fig. 23)If unavailable, observe

178-2 WIRING EXAMPLE• Fit the power supply wiring of each unit with a switch and fuse as shown in the drawing.COMPLETE SYSTEM EXAMPLE (3 systems) 1. W

English 11. SAFETY CONSIDERATIONS ... 12. BEFORE INSTALLATION ...

183. When including BS unit NOTE1. A single switch can be used to supply power to units on the same system. However, branch switches and branch circui

198-4 COMPUTERISED CONTROL (FORCED OFF AND ON/OFF OPERATION) (1) Wire specifications and how to perform wiring • Connect the input from outside to ter

209-1 SETTING AIR FILTER SIGN•Remote controllers are equiped with liquid crystal display air filter signs to display the time to clean air filters.• C

(0407) HT3PN01417-9V EM04A013Daikin US Corporation375 Park Avenue, Suite 3308New York, NY 10152��[email protected] ��

1VRV SYSTEM Inverter Air ConditionersInstallation manualCONTENTS1. SAFETY CONSIDERATIONS ...

2• Carry out the specified installation work after taking account of strong winds, typhoons or earthquakes.Improper installation work may result in th

3NOTE• Install the indoor and outdoor units, power supply wiring and connecting wires at least 3.5ft. away from televisions or radios in order to prev

42-1 ACCESSORIESCheck the following accessories are included with your unit.2-2 OPTIONAL ACCESSORIESFOR THE FOLLOWING ITEMS, TAKE SPECIAL CARE DURING

52. Items to be checked at time of delivery* Also review the “SAFETY CONSIDERATIONS”Points for explanation about operations2-3 NOTE TO THE INSTALLERBe

6(2) Consider whether the place where the unit will be installed can support the full weight of the unit, and reinforce it with boards and beams, etc.

7(c) Secure the installation panel (1) to the wall using either screws or bolts.• If using the attachment screws for the installation panel (2), attac