Daikin BRC7E61W Manual de instalación descargar pdf (Pagina 15)

Remote Controller (Wireless Type) OH08-1

42 Control Systems

· How to insert the batteries

Open the back cover of the remote controller by sliding it in the

direction of the arrow.

Insert the attached dry cell batteries. Properly insert, set the

batteries by matching the (+) and (–) polarity marks as indi-

cated. Then close the cover as before.

3. RECEIVER INSTALLATION

(1) Preparations before installation

Install this kit after installing the decoration panel.

Remove the suction grille and the air filter according to the instructions in the installation manual

attached to the decoration panel.

Remove the control box lid according to the instructions in the installation manual attached to the

indoor unit.

(2) Determination of address and MAIN/SUB remote controller.

If setting multiple wireless remote controllers to operate in one room, perform address setting for the

receiver and the wireless remote controller.

If setting multiple wired remote controllers in one room, change the MAIN/SUB switch of the receiver.

SETTING PROCEDURE

1. Setting the receiver

Through the small opening on the back of the receiver, set the wireless address switch (SS2) on the

printed circuit board according to the table below.

When using both a wired and a wireless remote

controller for 1 indoor unit, the wired controller

should be set to MAIN. Therefore, set the MAIN/SUB

switch (SS1) of the receiver to SUB.

After completing setting, seal off the opening of the address switch and the MAIN/SUB switch with the

attached sealing pad.

Unit No. No. 1 No. 2 No. 3

Wireless address

switch (SS2)

MAIN SUB

MAIN/SUB

switch (SS1)

SS1

SS2

Small opening

Sealing pad

Receiver

1 2 3

C: 3PA59585-23Y-3

1 2 ... 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Daikin BRC7E61W Manual de instalación Pagina 15